TOA Quick Primer ทีโอเอ ควิก ไพรเมอร์ 18 L.

• Special Lime Primer made from super special resin acrylic.
• Protect alkali and efflorescence high performance protection destructive to work.
• Special properties that immediately apply after Acrylic Alkali Resisting Primer was dry,Just only 2 days.
• Dirty stain protection from surfaces,  Both absorb and adhere the surfaces better than normal primers.
• Link between cement and colour film to enhances the adhesive performance of topcoat.
• Breathy film for inflated colour protection.

FEATURES

• TOA Quick Primer is based on super acrylic solvent base that designed for use as pigmented primer. The properties of this product are excellent alkaline resistance and superior pH balance that protect topcoat from efflorescence in cementitious materials after drying for 2 days. This product is super bonding agent that provides excellent adhesion between the substrates and paint film as well as it forms a breathable film that allows the releast of water vapor from substrates through out of the paint film to eliminate the risk of blistering.

• New surface

• • Allow the surfaces dry at least 2 days in case of speedy work.

• • The surfaces must be clean and free of dirt, grease, oil, wax, salt and other contaminants.

• • TOA Acrylic Sealent or TOA Acrylic Filler is used to repair all cracks and rough surfaces.
• Old surface

• • The surfaces must be clean and free of dirt,wax,salt,old paint and other contaminants.
  • Chalky surfaces or loose material must be removed by stiff brush.

• • TOA113 Microkill is used to get rid of algae and fungi that left on the surfaces.

• • The surfaces must be clean with suitable cleansing solution and water then rinse thoroughly with fresh water and allow to fully dry.

• • TOA Acrylic Sealent or TOA Acrylic Filler is used to repair all cracks and rough surfaces.

• Primer

• • Apply by brush with TOA Quick Primer 1 coat.
• Topcoat
  • Can be topcoat with Acrylic Emulsion Paint and Alkyd Base Enamel Paint.

• The temperature of the substrate should be minimum 10 ํC and at least 3 ํC above the dew point of the air, temperature and relative humidity measured in the vicinity of the substrate. Good ventilation is required in confined areas to ensure correct drying.